
Hello, neighbor
Dustless Hardwood Refinishing in Greater St. Louis
Sand, stain, and refinish your existing wood floors - dust-contained, low-VOC, and ready to walk on the same week, anywhere in Greater St. Louis.
- ✓4.9 · 88 Google reviews
- ✓0% APR financing
- ✓Lowest-price guarantee
Schedule a free estimate
The oak is probably still under there
Half the refinishing calls we get start the same way. Somebody pulls back a corner of carpet in a 1920s bungalow or a 1960s ranch and finds red oak strip flooring that has not seen daylight in forty years. Nine times out of ten it is worth saving. Sanding, staining and coating an existing floor costs a fraction of tearing it out, and you keep the tight old-growth grain that nothing sold today can match.
Veteran Flooring refinishes solid hardwood, parquet, and engineered floors with a wear layer thick enough to take a sanding. We work all over the region, from city homes with original oak to mid-county ranches with parquet in the den. When a floor is genuinely too far gone, we say so instead of taking the job and hoping the sander sorts it out.

Three ways to do it, and the lightest one that works
Not every floor needs to go back to bare wood. A full sand takes thickness off a floor you only get to sand so many times, so we start by looking at what is actually wrong with yours. Surface scuffs, worn traffic lanes and deep gouges are three different problems with three different price tags, and we quote the lightest fix that will genuinely solve it.
- Screen and coat - a light abrasion and a fresh coat of finish, one to two days, same color. Good for floors that are dull rather than damaged.
- Buff and coat - takes out light scratching and traffic wear without a full sanding, two to three days, same color.
- Full sand and refinish - down to raw wood, removes gouges, pet stains, water marks and old finish, and it is the only route to a different stain color. Three to five days.
- Board replacement first where water sat or a wall came out, then the whole floor refinished as one surface. That kind of work is its own conversation, covered on our floor repair page.
- Stairs sanded and coated at the same time so the run matches the floor it lands on

Financing Through Hearth And Synchrony*
*Subject to credit approval. Applying takes a few minutes and does not commit you to a project. Ask about our veteran and first responder discounts when you schedule.
See financing optionsStain samples on your floor, not in a catalog
This is the part people remember. Once the floor is sanded raw, we mix stains and brush them out in a low-traffic corner of your actual room. Natural, a mid-tone oak, a gray, an espresso, whatever you are weighing against each other. Then we leave them alone and come back a couple of hours later. Red oak throws pink under some stains and reads warm under others, and no chip in a book will tell you that in advance.
We send photos as the job moves along so you can watch the color go down even if you are at work all week. Water-based finish is low odor and walkable the same evening. Oil-based ambers a little as it ages, and some people want exactly that warmth. Homeowners tend to mention this stage in their reviews more often than the sanding itself.

Dustless means dustless
Our sanders run to commercial HEPA vacuums that pull dust at the drum, and we tape plastic containment across doorways and return vents. There is still a little fine dust, and anybody promising you zero is stretching it, but you are not finding oak dust on your kitchen dishes a month later. Most families stay in the house through the project. We work one zone at a time so you keep a bathroom, a bed, and a clear way in the front door.
Winter is a good season for this work. Salt and grit tracked in from the driveway is what grinds a finish down at the entries, so coming out of that stretch with fresh coats sets the floor up well for the year. Ask about it when you book a free in-home assessment and we will look at the whole floor, not only the room you called about.

Refinishing pricing in Greater St. Louis
Priced per square foot of floor being refinished. Larger jobs come down per foot, and everything gets quoted in writing after we walk the house.
| Option | Typical price | Notes |
|---|---|---|
| Screen and coat | $2.25 - $3.25 / sq ft | Dull finish, no color change |
| Buff and coat | $3.00 - $4.00 / sq ft | Light scratching and traffic wear |
| Full sand, sealer and two to three clear coats | $3.50 - $4.75 / sq ft | Our most common job |
| Full sand with custom stain | $4.50 - $6.00 / sq ft | Color change, stain samples included |
| Stairs refinished with the floor | $55 - $90 per tread | Added to a whole-floor job |
The in-home assessment is free, and we will point you to the lightest method that actually fixes the problem, even when that is the cheaper line on this list.
Hardwood Refinishing - frequently asked questions
We pull up a floor vent and look at the cut edge of a board. Solid oak with a healthy amount of wood above the tongue has five or six sandings left in it. Engineered needs a three millimeter wear layer or thicker. If there is not enough left, a screen and recoat still buys years, or we talk about new hardwood.
Most families stay put. We section off the rooms being worked and run containment so the rest of the house stays livable. Water-based finish is walkable in about six hours and cured in a week. Oil-based needs a full day before light traffic and several weeks to fully cure. Keep pets off until we tell you it is clear.
Surface water marks sand right off. Black staining means water sat long enough to soak in and react with iron in the fasteners, and that often runs deeper than a sander can reach. We replace the worst boards, weave in matching stock so the seams disappear, and blend the finish across the repair.
Yes. Once the floor is back to raw wood it can go almost anywhere, from a soft natural to a warm mid-tone, gray, or a deep espresso. Red oak fights gray a little because of its undertone, so we sample it right on your floor and show you what it really does before you commit a whole house to it.
Generally a third to half the cost of a comparable new floor, and it takes less time out of your life. The ranges on this page are honest ones. If the timing is awkward we can put it on a payment plan through our financing options. The written quote comes after we walk the floor, never over the phone.
Explore related flooring options
From the first call to the final sweep
Working with Veteran Flooring
Tell us what you have
Call {{phone}} or send us the rooms and square footage. We will set a time at your place, or you can stop by the showroom.
Measure and quote
Erik measures, checks the subfloor, and writes one price for the whole project, back to you within one business day.
Install with the owner on site
We protect the house, prep the subfloor, and lay the floor. {{ownername}} is there while the work happens.
Walk it and stand behind it
We clean up, walk every room with you, and back our labor for a full year on top of the manufacturer warranty.

Reviews
4.9 stars from 88 Google reviews, written by homeowners across Greater St. Louis.
Read what they said →
Free estimate
We measure the space and get one written price back to you within one business day.
Schedule yours →
Services
Installation, hardwood refinishing, repair, tear-out and subfloor prep, for homes and commercial spaces.
See what we do →What we stand for
What we hold ourselves to
The owner on site Dale Wyatt is on your job while the work happens. Questions about a transition, a stain color, or what we found under the old carpet get answered by the person accountable for the floor.
One honest number Erik measures the rooms and checks the subfloor before he quotes, so the written price covers the whole project. It does not grow halfway through the install.
Certified craft We are certified by the National Wood Flooring Association, bonded and insured, and our team carries more than 80 years of combined experience in this trade.
You hear from us You get a schedule, progress photos while the crew works, and a straight answer the day something under the old floor changes the plan.

Take a peek
See it in a real room
Browse hardwood, refinished oak, luxury vinyl and tile we have installed in {{areaName}} homes, then bring your favorites by the showroom.
Right around the corner
Serving families across Greater St. Louis
We work out of Maryland Heights and cover the city, mid-county, and St. Charles County: century-old brick two-flats, postwar ranches, and new builds alike. One hallway or the whole house, we will come look at it and give you a straight price.
- Maryland Heights, MO
- St. Louis, MO
- St. Charles, MO
- O'Fallon, MO
- St. Peters, MO
- Chesterfield, MO
- Florissant, MO
- Wentzville, MO
- Wildwood, MO
- University City, MO
- Ballwin, MO
- Kirkwood, MO
- Webster Groves, MO
- Hazelwood, MO
- Creve Coeur, MO
Good to know
Straight answers about your floor.
Here is what homeowners in {{areaName}} ask us most: view our full FAQ
Fresh off the press
Industry guidance at your fingertips
Request a consultation
Meet with one of our skilled project specialists to get started
Featured Brands & Technologies
















